Forum Replies Created

Viewing 8 posts - 1 through 8 (of 36 total)
  • Author
    Posts
  • in reply to: Proton basic program problem with 12F683 #10386
    piero55
    Participant

    Good, we have come to the conclusion….. They arrived to me 10 pic new and these work perfectly. I therefore find myself having 10 pic “bogus”….. Ah, how much time wasted!!!

    in reply to: Proton basic program problem with 12F683 #10377
    piero55
    Participant

    I thought about it, as soon as I have time I try.

    in reply to: Proton basic program problem with 12F683 #10373
    piero55
    Participant

    Sorry, I badly explained myself…. the fw of the pic working, put in the pic “defective” does not work….

    in reply to: Proton basic program problem with 12F683 #10364
    piero55
    Participant

    Further proof: i read the pic it works and i wrote the fw on a pic “defective”. FW working, pic, NO
    10 New PICs, dead???

    • This reply was modified 8 months, 1 week ago by piero55.
    • This reply was modified 8 months, 1 week ago by piero55.
    in reply to: Proton basic program problem with 12F683 #10341
    piero55
    Participant

    Ciao, I did a lot of tests…. lastly, I put the wrong pic in the power supply where there is one that works perfectly. It just doesn't work…. And, the logic analyzer is the one in the photo above in this 3D and as a SW I use pulseview or logic 1.2.18. I'll try again tomorrow as soon as I have some time. However I have recreated the SW with MBPro and it doesn't work anyway. I have only one proof left : read the pic it works, and transfer in FW on the wrong pic. I don't know what else to say, however I do not desist and wait for the other pic to be delivered to me….

    in reply to: Proton basic program problem with 12F683 #10336
    piero55
    Participant

    I resume this discussion: i can't figure out if the pic 12F683 is broken or not. not him 10 new and all have the same problem, in simulation everything perfect, in reality they do not go. I tried to swap the GP0,1,2 between them but where I apply a trimmer everything is fine, where I connect a LM335 (that with a multimeter responds perfectly) there is no way to make it work. I have converted the program to MBPro, same exact problems. I have converted the program to a 12F675 and the same circuit works fine. I modified an output with the Rsout command, and with a logic analyzer, I see a train of impulses coming out but I can't interpret it, I never did it. But, when i started this project, I was using a 12F683 from another supply (I only had one) and that works, possible that all the other pic are dead? Now I have ordered more 10, it will take time to get them……. I do not know what to do…….

    in reply to: Help to write and publish an article #10177
    piero55
    Participant

    Perfect, tranquillo sono solo immagini autoprodotte senza pubblicità di nessun genere: grazie procedo con la redazione dell’articolo.

    in reply to: Help to write and publish an article #10172
    piero55
    Participant

    Thank you for your answer, the screen is that, solo che manca completamente il tastoAggiungi Media”.
    Senza quello, non si possono inserire foto e altro: solo testo.
    E’ come se mancassero autorizzazioni o simili.

Viewing 8 posts - 1 through 8 (of 36 total)
VOTE