16 July 2018 at 10:39
#3561
Participant
“They probably are errors that occur in the Master's firmware in some particular condition. You'll have to find a way to live with it because they do not think we'll find out what it is and fix it”
Bad news comes upon me.
I prepare this new low speed test.
Even with the increase in microstep there have been improvements.
But then is not that I want to go 100 but currently CNC Theremino when it receives a file as “money” go slow with even if the feed block 2000 and it is them that are lost steps.
The new changes announced CNC can help?
About almost forgot… I noticed that in some moments light up slot values 1000 which does not appear in configuration. Typically the 23 e 24. Currently there is only one master unused pin.
Greetings.